1. Power camera via POE and log into the camera interface
   1. If connecting to DHCP source like a router or managed switch, run our IP Scanner to find it on the network
   2. If connecting to non-DHCP source like an unmanaged switch, it will default to IP address 192.168.226.201
      
      
2. Log into the camera interface
   1. Username: admin
   2. Password: 1234
      
      
3. Go to Config > Network > Ports and Connections > Wi-Fi
   
   
   
   
   
   
4. Click Enable
   
   
   
   
5. Click on the desired Wi-Fi source under Wi-Fi Networks
   
   1. Enter the password in the section labeled Key 1
   2. Choose either DHCP or Static for the IP address
   3. Click Save
      
      1. NOTE - The doorbell will only see 2.4 GHz Wi-Fi sources, not 5 GHz
         
         
   
   
   
6. Although the configuration is done, while connected to the POE, it will always say "Disconnected" in the connection column. This is normal.
   
   
   
   
7. At this point, remove the POE and add either a 12V power supply or the included CCTV power converter
   1. 
8. Once the camera powers back up, it will then connect to Wi-Fi and be findable on the wireless network

Initial submission Date: April 8, 2025

Article authored by: Christopher Cataldo, Tier 1