How to install the MD-JBA with a MegaDome G3 series camera.

Super Admin
06 May 2026
0 views

Issue:

An installer needs the proper installation steps for the MD-JBA.

Resolution:

  1. Remove the magnetic mounting plate from the bottom of the MegaDome G3.

    MD-JBA_install_1.jpg

  2. Position the mounting plate onto the MD-JBA, aligning the set of holes labeled "A".

    MD-JBA_install_2.jpg

  3. Install the rubber grommet for the Ethernet cable. Align the hole with the camera and mounting plate.

    MD-JBA_install_7.jpg

  4. Attach the camera onto the mounting plate.

    MD-JBA_install_3.jpg

  5. The area where the mounting plate and the MD-JBA meet can be a weak point in the mount. Be sure to seal this with a sealant like silicon if water is a hazard.

    MD-JBA_install_4.jpg

  6. Tighten the 4 screws located on the camera body to affix it to the MD-JBA.

    MD-JBA_install_5.jpg
    MD-JBA_install_6.jpg

Was this article helpful?

Bu bilgiler sorununuzu çözmeye yardımcı oldu mu?

Still need help?

Uzman ekibimiz size yardımcı olmak için burada.

New Ticket