Annke Vision - How to Connect I51CE to DVR?

Applies to:

camera:I51CE

DVR:DW41JD/DW81KD/DW61LD

Purpose: Adding a WIFI camera to Annke's DVR

Here are the steps:

1.  Please connect the camera to a 12V DC power supply (must be 12 Volt, can be 1 Amp or above) and to a broadband router by ethernet cable.

2. And then, please visit the camera via the web first. Here is a link for your reference:

Annke Vision -- How to Access the Web interface of ANNKE PoE Cameras via Browser? (Without NVR)

Please take down the camera's IP address like this picture shows.

3. Please click configuration>network>advanced settings>WI-FI>Please click enable>choose your Wi-Fi in the wireless list>please input the information of your WIFI>click save.

4. Please connect your DVR to your router by using a network cable.  After that, you can find the DVR is detected by the sadp Tool. Please double click the ip address>input the username and password of the DVR. 

5. Please go to configuration>camera management>ip camera>you can find that the camera is detected by the NVR>please select it>click modify. 

6. Please input the IP address of the camera>choose IPCAM in the Protocol>please input the activation password of the camera>click ok.

7. After the WI-FI camera is connected to the DVR successfully, there will be a 'Play' icon under the 'IP Camera' setup. You can go to go to 'Live View' to see the image of WI-FI camera.

8. After that, you can disconnect the network cable between camera and router.

If you have any other questions, please contact ANNKE technical support at support@annke.com by email.