How to use a camera with relay output simulating a Safire 2nd Generation Video Doorbell Touch Exit Button

With a Uniview camera with relay output simulating a Touch Exit to the Safire 2nd Generation video door entry system.

A zone is drawn in motion detection and if the camera detects movement the camera will send a signal to the video door entry system and open the door.

The camera output relay must be set to NO.

Now it is a matter of making the right connections in the SF-VIMOD-CAM-IPboard

Its connections are:

NC1

NO1 Negative wire of the 1st Led simulating a door

COM Red wire bridged with GND and blue wire the com of the Touch Exit button

Door = NC2

NO2 Negative red wire of the 2nd LED simulating another door

GND Black wire from the GND of the Touch Exit Button

12VDC Red wire from the positive of the push button and the positives of the Leds

GND Red wire bridged with COM and the GND of the camera with relay output

AIN2

AIN1

Alarm=AIN3

AIN4 Green wire NO from the push button and the red wire from the camera with relay output

This installation is made in such a way that I can open door 2 (LED2) with the push button and with the camera when it detects movement in the area I have drawn. Door 1 (LED1) will be opened with the Sub module SF-VIMOD-CARD-MF.

We can use AIN3 or AIN4 to simulate doors

The same example with a camera with relay output and a door without leds.