Setting up face detection and face comparison in Uniview

• Face detection: It is used to detect faces. The configuration of this event is done through the camera itself or the nvr, although it is recommended from the camera as it has a more complete menu.

Activate the event and enter its configuration.

Enable and configure both the actions and the schedule. Save.

• Facial comparison: It is used to compare the events generated by the Facial Detection, as well as to perform searches.

A list is created and the different users/faces are added to it, adding characteristics of this profile and registering it with an ID.

Then, the facial comparison is enabled and the settings of the same are accessed

• Point 1 - The new monitoring task is created
• Point 2 - Select the list that was created earlier. This allows each new task to compare faces from a different list and generate different actions for each one
• Step 3 - Select whether you want this task to be for matching faces, non-matching faces, or both
• Point 4 - Select the actions that you want to execute when the comparison is matched or not matched, it can be from sending an email, a push notification, recording a channel, etc
• Point 5 - Leave the task ON to be executed

Searching for detections and facial comparisons

By clicking on the search 3 menus appear.

• Search by detected faces: It bases its search on the detected faces.
• Search by comparison of detected faces. It bases the search on the comparison of previously detected faces. Even through your name or id created in your personal file.
• Search by attributes. It bases the search on certain physical characteristics.

Within the face search, you can select and add directly to one of the lists:

In the detected faces search, users can be added to the library directly.