Teltonika - Configure the connection of the trackers to the AIKO platform

After filling in the APN information in the tracker, it is necessary to indicate the information of the server to which they will connect to send the data. In order for Teltonika equipment to communicate with the AIKO platform, the following procedure must be followed:

• Create an AIKO account

First, the tracker must be connected to the PC. This can be done in two ways:

1) Via USB: to do so, it will be necessary to install the "Teltonika USB communication driver", which can be downloaded from the following link (https://athena-visiotech.s3-eu-west-1.amazonaws.com/jXC1eYcBB1-tZqTHVjH0/TeltonikaCOMDriver.zip).

2) Via Bluetooth: the device with the name "FMx_last_7_digits_of_IMEI", without LE at the end, must be paired with the PC using the PIN 5555.

After that, download the Teltonika Configurator software (it can be found in the download section of the product) corresponding to the model in question and select the tracker.

In the GPRS --> Server Settings tab, the server, port and communication protocol will be specified:

For the different trackers, the data are as follows:

Protocol: TCP

Domain: d.aikotelematics.com

Port TK-FMB003/FMC003: 2730

Port TK-FMB130: 2587

Port TK-FMC130: 2585

Port TK-FMB140: 2570

Port TK-FMP100/FMT100: 2750

Port TK-FMB640/FMC640: 2720

Finally, click on the "Save to device" button to save the changes to the device.